Watch servicing: how often, how much and by whom
A mechanical watch needs a full service every several years: the movement is taken apart, cleaned, oiled, reassembled and regulated. How often depends on the maker's guidance and how the watch is used, the cost varies widely with the brand and the complexity, and you can choose between the manufacturer and an independent watchmaker.
Why a watch needs servicing
A mechanical movement has well over a hundred parts, many of them turning constantly on pivots finer than a pin. They rely on tiny amounts of oil. Over the years the oil thickens, migrates or dries, and metal starts to wear against metal. The watch may keep running while this happens, which is why "it still works" is not proof that all is well.
What happens in a full service
- Assessment. The watchmaker checks timekeeping on a timing machine, inspects the case and gives an estimate.
- Dismantling. The movement is removed from the case and taken apart completely.
- Cleaning. The parts are cleaned in a machine using special fluids, then inspected.
- Replacement of worn parts. The mainspring is commonly replaced, along with anything worn or damaged.
- Reassembly and lubrication. The movement is rebuilt with several different oils and greases, each in its proper place.
- Regulation. The rate is adjusted and tested in several positions.
- Casing. New gaskets are fitted, and a watch meant for water is pressure tested.
How often
There is no single rule. Manufacturers' own recommendations differ, from around every five years for many watches to nearer ten for some modern movements with improved lubricants and materials. Older advice of every three to five years is still commonly quoted. Follow the maker's guidance for a modern watch.
For a vintage watch, how much you wear it matters. Collectors with several watches in rotation often stretch the interval for pieces that are worn only occasionally, on the reasoning that a watch run for a few days a month does little wear. That is a judgement call. What you should not do is wear a watch daily for years on old, dried oil.
Whatever the calendar says, have a watch looked at if you notice any of these:
- It suddenly gains or loses much more time than before.
- The power reserve has dropped and it stops overnight.
- Winding feels gritty or stiff, or the crown is hard to pull out.
- There is condensation under the crystal. Treat this as urgent, because moisture causes rust quickly.
A watch that suddenly runs very fast may only be magnetised, which is a quick and inexpensive fix. See watch storage, boxes and winders.
How much
Costs vary so widely that any single figure would mislead. The main things that move the price are:
- Complexity. A time-only watch costs least. A chronograph or calendar watch costs considerably more.
- Brand. Servicing through the manufacturer of a luxury watch is normally the dearest route.
- Parts. Replacement parts are charged on top, and scarce vintage parts can be expensive or have to be made.
- Condition. Water damage and rust can turn a routine service into a restoration.
On an inexpensive watch a full service can cost as much as the watch is worth. That is worth knowing before you buy an unserviced bargain. Always ask for a written estimate first, and ask to be contacted before any extra work is done.
Brand service or independent watchmaker
| Manufacturer's service centre | Independent watchmaker | |
|---|---|---|
| Parts | Full access to genuine parts | Depends on the brand; some restrict parts supply |
| Cost | Usually higher, often a fixed price list | Often lower, quoted per job |
| Paperwork | Brand service papers, valued at resale | Invoice and often a timing printout |
| Vintage watches | May replace aged parts as standard, or decline very old models | Specialists will usually work to your instructions |
For a modern watch under warranty, the manufacturer or an authorised service centre is the simple choice. For a vintage watch, a good independent who knows that type of watch is often the better one, because they will preserve original parts when asked.
When choosing an independent, ask about training and accreditation, whether they have a parts account for your brand, what guarantee they give on their work and how long it will take. The British Horological Institute is the UK professional body for watch and clock makers and is a sensible place to start looking for a qualified repairer.
What to ask for
Put your instructions in writing when you hand over a collectable watch. A service centre's default is to return a watch looking as new as possible, which can remove exactly what a collector values.
- Do not polish the case unless you want it done.
- Do not replace the dial or hands. Ask to be consulted first if they think it necessary.
- Return all replaced parts. Old crowns, crystals, hands and movement parts belong with the watch.
- Provide an itemised invoice listing the work done and the parts fitted.
- Pressure test if the watch is meant to be worn near water, and say so on the invoice.
Quartz watches
A quartz watch needs far less. Replace the battery promptly when it runs down, because a dead battery left in place can leak and ruin the movement. Have the seals checked or replaced at the same time if the watch is used near water. Quartz movements can be serviced or, on inexpensive watches, replaced complete.
Next steps
- Watch movements explained: what the watchmaker is working on.
- Vintage watches for beginners: why original parts matter so much.
- Watch storage, boxes and winders: keeping watches safe between services.
- How to sell a watch: whether to service before selling.
- Back to the watch collecting guide.